Converters-Interfaces HART HRT-710

Description

The HART-710 Gateway is specially designed for the master device of HART protocol. It allows the Modbus master device to access the HART slave devices. These HART devices may be a transmitter, an actuator, a current output device and so forth. In addition, we also provide the utility software for users to configure the HART-710. By using this module, users can integrate their HART device into Modbus network easily.
Modbus is a widely used protocol that was developed with industrial applications in mind. HART protocol was developed for measurement applications. The HART-710 HART to Modbus gateway allows Modbus devices to be incorporated into HART networks.
Specifications
Hardware
CPU
32 bit, 100 MHz or compatible
SRAM/Flash/EEPROM
64 KB / 512 KB / 16 KB
Watchdog
Watchdog IC
ESD Protection
4 kV class A
UART Interface
COM 1
RS-232(3 wire)/RS-422/RS-485
COM 1 Connector
9-pin screwed terminal block
Baud Rate (bps)
1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200
Protocol
Modbus RTU / Modbus ASCII
Power
Power supply
Unregulated +10 ~ +30 VDC
Power Consumption
1W
Protection
Power reverse polarity protection, Over-voltage brown-out protection
HART Interface
HART Interface
2-pin screwed terminal block
HART Channel
1
Environment
Operating Temperature
-25 to 75 °C
Storage Temperature
-30 to 85 °C
Humidit
5 to 95% RH, non-condensing
Mechanism
Dimensions
108mm x 72mm x 35mm(H x W x D)
Installation
DIN-Rail or Wall Mounting